Voice Recorder Board WITH WIRES for IDOM4

Voice Recorder Board WITH WIRES for IDOM4
Voice Recorder Board WITH WIRES for IDOM4 Voice Recorder Board WITH WIRES for IDOM4
Product Code: SD1820-VB-WIRES
Price:$14.95


5 or more $13.95
Qty:     - OR -   Add to Wish List
Add to Compare

With a special easy cable pre-soldered to the audio board that makes it very easy to add to your IDOM4 (or IDOM3). Simply use the IDOM4 manual to see what wires go where on the IDOM4, plug them in and solder. NO stripping 10 ends of wire! (wire colors may vary)

ID your repeater, build your own voice keyer or just annoy your family and friends. This is the voice recorder board used with the ID-O-Matic IV repeater controller. This board will record and play back a 10-second voice messsage. Simple to use; hold down the REC button to record the message, and press the PLAY button to play the message back. The on-board audio amplifier is enough to drive a small 8 Ohm speaker, and there is a microphone on board as well.

These boards have no header pins or speaker connectors, since they are not needed with the ID-O-Matic. Solder pads are provided for off-board connections.

Specs:

  • Main chip: ISD1820
  • Operating voltage:3 - 5VDC
  • Recording time: 10 seconds
  • Can be used as a loudspeaker module
  • Loop or single-pass playback
  • Can be controlled with single-chip controller
  • Can directly drive 8 Ω 0.5W speakers
  • PCB Dimension: 38mm * 42.5mm
General Information
Assembly
This product is fully assembled. Special 5 conductor color coded wires are installed, making it easy to connect to your ID-O-Matic III or IV, SEE IDOM4 (or 3) manual for correct wiring to your IDOM4 (or 3)
Specifications
Inputs
Edge-triggered playback, level-triggered playback, record
Outputs
Audio signal, single-ended or speaker drive available on board
Power requirements
DC 3-12 V

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



HamGadgets © 2017